Question of the Week · Week of November 18, 2026

What Should a Commercial Roof Inspection Report Show?

Say what the report covers, and say what it does not. On Episode 014, Steve Reiss of Division 7 Roofing says that onus is his. An aerial inspection points out obvious catastrophic issues. It does not tell you the moisture content in the roof. On Episode 012, Bilal Sher of Building Diagnostic Robotics says the contractor hands the owner the report and tells them the problems and how to fix them.

Question of the Week for the week of November 18, 2026. Cited from Episode 014 and Episode 012. Related: How drones are used in roofing. No guest on these episodes stated an inspection price. Have a question for the show? Contact Roofing Authority Network.

Say what the report covers, and what it does not

On Episode 014, Steve Reiss says the gap is between what the report was designed to inspect and what the owner assumes. He sets that standard himself.

I put the onus on myself to set the, uh, to set the standard on what the report is saying and what it's not saying

Steve Reiss · Episode 014 · 01:10:28. Field Edition · Play 01:10:28

it's really important to know what it's not saying.

Steve Reiss · Episode 014 · 01:10:28. Field Edition · Play 01:10:28

it's not saying that this roof is 100% deficient free.

Steve Reiss · Episode 014 · 01:10:28. Field Edition · Play 01:10:28

it's saying that based on a tool that was used, there's no obvious issues. Let's get on the roof now and do a thor- a more thorough inspection

Steve Reiss · Episode 014 · 01:10:28. Field Edition · Play 01:10:28

An aerial pass shows the obvious damage

Later on the same episode, Steve says the scope of that tool is the obvious catastrophic issues. Moisture, later foot traffic, and the roof's age, when the age was not given, are outside it. A known age changes the recommendation.

This tool is designed to give us an aerial inspection that is gonna point out obvious catastrophic issues. It's not going to tell us the moisture content that's in the roof right now.

Steve Reiss · Episode 014 · 01:11:53. Field Edition · Play 01:11:53

It's not gonna tell us, you know, the foot traffic that's gonna happen after this drone is gone.

Steve Reiss · Episode 014 · 01:11:53. Field Edition · Play 01:11:53

If I knew that the, that the roof was, you know, 25 years old, that's gonna change the recommendation.

Steve Reiss · Episode 014 · 01:11:53. Field Edition · Play 01:11:53

it can't prove anything, right?

Steve Reiss · Episode 014 · 00:15:47. Field Edition · Play 00:15:47

we've always gotta have, um, you know, someone verifying on the roof.

Steve Reiss · Episode 014 · 00:15:47. Field Edition · Play 00:15:47

Document every deficiency the walk can see

Earlier on Episode 014, Steve says the post-storm visit is an inspection that documents what happened, what needs work now, and what can wait. A ballasted roof changes what that walk can show, because the seams are under the rock. Even a boots-on-the-roof report is not every seam.

helping them understand what happened to the roof, what needs addressed now, and what can wait.

Steve Reiss · Episode 014 · 00:07:30. Field Edition · Play 00:07:30

we provide those roof assessments and inspections that document every single deficiency on the roof.

Steve Reiss · Episode 014 · 00:08:34. Field Edition · Play 00:08:34

if you have a ballasted system, you can't see the seams, right?

Steve Reiss · Episode 014 · 00:08:34. Field Edition · Play 00:08:34

You have to shovel a bunch of rock out of the way.

Steve Reiss · Episode 014 · 00:08:34. Field Edition · Play 00:08:34

we're not going and probing every single seam, right?

Steve Reiss · Episode 014 · 00:15:47. Field Edition · Play 00:15:47

A clean report still gets checked

When the ceiling is wet and the report was clean, Steve asks what happened on the roof after the report. He verifies on the roof and from the underside. He does not sell the scan as the whole answer.

what has taken place since that roof report was generated?

Steve Reiss · Episode 014 · 01:09:07. Field Edition · Play 01:09:07

Has there been, um, other trades up there doing maybe HVAC work?

Steve Reiss · Episode 014 · 01:09:07. Field Edition · Play 01:09:07

has there been, yeah, high winds, high rain

Steve Reiss · Episode 014 · 01:09:07. Field Edition · Play 01:09:07

when the roof scan comes back clean, we need to verify

Steve Reiss · Episode 014 · 01:17:01. Field Edition · Play 01:17:01

go to the underside, understand that

Steve Reiss · Episode 014 · 01:17:01. Field Edition · Play 01:17:01

I'm not selling, you know, AI roof inspections to people, um, under the premise that this is the end-all, be-all

Steve Reiss · Episode 014 · 01:17:01. Field Edition · Play 01:17:01

What a scan can put in the report

On Episode 012, Bilal Sher says a ground-penetrating radar scan shows where moisture is taking up the signal, the taper and whether it comes from the deck or the insulation, and the deck material. What else belongs in the report depends on the market. Ryan Resides of Division 7 Roofing says a traditional infrared scan waits until about an hour after the sun has left the roof. The same pass can be a moisture scan and a look for visual defects. Bilal says the data still needs a contractor, and a core cut, before a large decision.

Where it gets absorbed more is where you have moisture

Bilal Sher · Episode 012 · 00:29:42. Field Edition · Play 00:29:42

you can figure out the, the taper, uh, whether it comes from the deck or whether it's coming from the insulation

Bilal Sher · Episode 012 · 00:29:42. Field Edition · Play 00:29:42

whether it's concrete with rebar, whether it's a metal deck, whether it's a wood deck, whether it's a composite deck

Bilal Sher · Episode 012 · 00:29:42. Field Edition · Play 00:29:42

information related to, uh, insurance and related to past cases of, uh, roofs being replaced added to reports

Bilal Sher · Episode 012 · 00:26:37. Field Edition · Play 00:26:37

is it better to re-coat, is it better to do a layover

Bilal Sher · Episode 012 · 00:26:37. Field Edition · Play 00:26:37

gives the data, the nicely made reports to the building owner, and then tells them that, "Your roof has these problems. Here's how you fix it."

Bilal Sher · Episode 012 · 00:34:45. Field Edition · Play 00:34:45

if you're gonna be making million-dollar decisions, I think it still makes sense to do a core cut

Bilal Sher · Episode 012 · 00:46:01. Field Edition · Play 00:46:01

approximately an hour after the solar load has left the roof is when- Yeah we want to start those infrared scans.

Ryan Resides · Episode 012 · 00:36:55. Field Edition · Play 00:36:55

we're getting a, essentially a moisture scan report

Ryan Resides · Episode 012 · 00:36:55. Field Edition · Play 00:36:55

visible spectrum cameras on it that are, that they are using AI to detect visual defects

Ryan Resides · Episode 012 · 00:36:55. Field Edition · Play 00:36:55

Questions this record can answer

What should a commercial roof inspection report say it covers?

Steve Reiss says he sets the standard for what the report is saying and what it is not saying. It is not saying the roof is 100% deficient free. Based on the tool that was used, it is saying there are no obvious issues, and then someone gets on the roof for a more thorough inspection.

What does an aerial inspection show, and what does it miss?

Steve Reiss says the tool points out obvious catastrophic issues. It does not tell you the moisture content in the roof, the foot traffic after the drone is gone, or the roof's age when that age was not given. A known age of 25 years changes the recommendation.

What should the report tell the owner to do?

Bilal Sher says sensors and data by themselves cannot do anything. The roofing contractor gives the owner the report and tells them the problems and how to fix them. Before a million-dollar decision, he still wants a core cut to verify. What else is in the report depends on the market: hurricane markets want insurance history and past replacements; other markets want a capital plan and options such as a re-coat or a layover.

What if the report is clean and water shows up inside?

Steve Reiss asks what has taken place since the report was generated, including other trades such as HVAC work, and high winds or high rain. A clean scan still has to be verified on the roof and from the underside. He does not sell the report as the end of the inspection.

Have a question for the show? Contact Roofing Authority Network.