From Episodes 006, 001, and 014 · November 16, 2026

How are drones used in roofing?

On Tie-In episode 006, Keith Bilous says a drone sees the roof before an estimator does, and David Tran says that scan becomes a 3D replica people can inspect and measure without standing on it. Ryan Resides says the flight is about speed: it points the estimator at the obvious problem, and it does not replace a boots-on-the-roof inspection, because a finding still has to be confirmed on the roof. John Kiesel says on episode 001 that the camera gets there without a ladder, and Steve Reiss says on episode 014 that an aerial inspection points out obvious catastrophic issues and does not tell you the moisture content.

Cited from Episode 006, Episode 001, Episode 004, and Episode 014, and from 006, 001, 004, and 014. Watch the drone hour: YouTube replay. Have a question for the show? Contact Roofing Authority Network.

What the flight is for

Keith's open is the job he is willing to give the aircraft: the first look is a scan, and the trade sharpens rather than shrinks. David Tran's definition of the result is a 3D replica of the roof or structure. He says people can do walkthroughs and measure on that replica without being on site, and that once a condition can be seen it can be measured, planned, and budgeted. Ryan says the same pass is a cursory look at general condition. It points the estimator at what he calls the smoking gun, so the time on the roof goes to a few specific areas.

they can, uh, inspect it just like they were on site without having to be there, right? So they can do walkthroughs, they can measure, can really do anything that they want on this, this, uh, three-dimensional replica

David Tran · Episode 006 · 00:33:00. Field Edition · Play 00:33:00

The first look is a scan

Keith Bilous · Episode 006 · 00:01:00. Read the episode · Open this minute

What to use it for, and where it stops

  • Use it for the first look and for a general condition picture. Keith Bilous, episode 006, 00:01:00. Ryan Resides says that look is about speed, and that it points the estimator at the smoking gun instead of spending a lot of time looking at everything. 01:06:00.
  • Use the replica to inspect and measure without standing on the roof. David Tran, episode 006, 00:33:00. At 00:30:00 he says you cannot plan or budget a condition you cannot see and measure.
  • Use it when climbing is the risk. John Kiesel says on episode 001 that a drone gets to a roof quickly without climbing a ladder, and he calls that a toy turned into a tool. 00:16:00. On episode 006 at 00:52:00, Keith reads a comment from John that they will review a tornado-hit building that afternoon because it was too unsafe to get up on the roof.
  • Keep the picture. John says on episode 004 that drone imagery becomes information that does not get lost, does not forget, and is fact. 00:26:00.
  • Do not treat the flight as the whole inspection. Ryan says a drone still has no sense of touch, so small voids you find by stepping on them are tricky in today's drone inspections, and that when the drone sees something it has to be confirmed with boots on the roof. 01:05:00 and 01:07:00. Steve Reiss says nothing replaces boots on the roof entirely. Episode 014, 00:03:28.
  • Do not read moisture, later foot traffic, or an unknown age off the aerial picture. Steve says the tool points out obvious catastrophic issues, does not tell you the moisture content in the roof, does not tell you the foot traffic after the drone is gone, and often does not know how old the roof is. Episode 014, 01:11:53.
Hey, this isn't about replacing a boots on the roof inspection. This is about speed.

Ryan Resides · Episode 006 · 01:06:00. Field Edition · Play 01:06:00

This tool is designed to give us an aerial inspection that is gonna point out obvious catastrophic issues. It's not going to tell us the moisture content that's in the roof right now.

Steve Reiss · Episode 014 · 01:11:53. Field Edition · Play 01:11:53

Questions this record can answer

Does a drone replace walking the roof?

No. Ryan Resides says on episode 006 that a drone inspection is about speed, not about replacing a boots-on-the-roof inspection, and that when the drone sees something it still has to be confirmed on the roof. Steve Reiss says on episode 014 that nothing replaces boots on the roof entirely.

Can a drone scan be used to measure a roof, on these episodes?

David Tran says on episode 006 that a digital twin is a 3D replica of the roof or structure, and that people can do walkthroughs and measure on that replica without being on site. He also says that once a condition can be seen, it can be measured.

What does an aerial inspection miss?

Steve Reiss says the aerial tool points out obvious catastrophic issues and does not tell you the moisture content, the foot traffic after the drone is gone, or the roof's age when that age was not given. Ryan Resides says today's drone does not have a sense of touch, so small voids that you find by stepping on them are tricky.

When do these episodes use a drone instead of a ladder?

John Kiesel says on episode 001 that a drone gets to a roof quickly without climbing a ladder. On episode 006, Keith Bilous reads a comment from John that they would review a tornado-hit building because it was too unsafe to get up on the roof.

Have a question for the show? Contact Roofing Authority Network.